Linear Collider Forum



Home » Simulation » Full Simulations » Recalibration needed after change in geometry ?
icon10.gif  Recalibration needed after change in geometry ? [message #2304] Mon, 24 February 2014 08:42 Go to next message
protopop
Messages: 5
Registered: January 2014
Location: UK
Let's say I tweak the ECAL geometry and I run a bunch of Mokka simulations with the new geometry.

When I want to run reconstruction afterwards, do I need to do any recalibration of the reconstruction parameters (for Pandora ?) or it's all done automatically based on the new Gear file which I provide?
Re: Recalibration needed after change in geometry ? [message #2305 is a reply to message #2304] Fri, 28 February 2014 04:15 Go to previous message
gaede
Messages: 232
Registered: January 2004
Location: DESY, Hamburg
It depends very much on the changes that you make to the geometry.
For example changing the thickness of the scintillator clearly requires new calibration, as would a change of the cell sizes.
In case of doubt, it is best to contact the Pandora experts directly.
-Frank.
Previous Topic:Re-running a given simulations set
Goto Forum:
  

[ PDF ]

Current Time: Mon May 21 02:17:53 Pacific Daylight Time 2018
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.1.
Copyright ©2001-2010 FUDforum Bulletin Board Software