Linear Collider Forum



Home » Analysis and Reconstruction » Analysis Tools » question on The Students' Getting Started Guide
Re: question on The Students' Getting Started Guide [message #1190 is a reply to message #1188] Fri, 12 October 2007 08:49 Go to previous messageGo to previous message
nomerot
Messages: 13
Registered: December 2005
Location: University of Oxford
hi Ian,

thank you for your reply.

I was not trying to compile in Netbeans - as the instructions rightly say:

If you encounter a red underline, it's a sign that Netbeans spots an error in your code.

so I was trying to figure this out. I tryed to locate aida.jar as you recommended and it was not in the same place from where I took lcsim.jar (I followed instructions to get lcsim.jar). I am not sure how to look for it otherwise - feel free to send me to relevant reading/links.

I read instructions to the end and I tryed to load Analysis103 in JAS3 to compile and to run it but I could not find where Netbeans saved it - hence my second question about how to save properly projects in Netbeans and how to load them then into JAS3. I guess it's related to the setting correctly Class Path in JAS3.

Thanks again for your help - I feel myself a student again indeed!

Best, Andrei
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:bug in FastMC in org.lcsim
Next Topic:how to get VtxBarrHits for a particle?
Goto Forum:
  


Current Time: Sun Jul 22 15:28:03 Pacific Daylight Time 2018
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.1.
Copyright ©2001-2010 FUDforum Bulletin Board Software