Linear Collider Forum



Home » Analysis and Reconstruction » Analysis Tools » how to get VtxBarrHits for a particle?
Re: how to get VtxBarrHits for a particle? [message #1201 is a reply to message #1200] Sat, 13 October 2007 13:20 Go to previous messageGo to previous message
kutschke
Messages: 16
Registered: June 2007
Location: Fermiliab

Hi Andrei,

The sandbox is a section of the cvs repository in which people
can put test/example/in-progress code. It is not built as part of the regular release.

To get it you need to check it out of cvs. The cvs instructions are at:

http://confluence.slac.stanford.edu/display/ilc/Building+org .lcsim+software

You will also need to build an up to date release to get Hans' and Dima's code. The jar files on the web are many months old.
The page I pointed you to, above, has instructions on building a release.

Before building a release you may need to know stuff from
all 4 bullets under "Installation Instructions" on:
http://confluence.slac.stanford.edu/display/ilc/lcsim+Tutori als

( the url above is the 4th bullet on this page ).

Sorry that this is not any easier but you are getting an accurate picture of the state of the software.

Rob


Rob Kutschke Computing Division, MS#234
kutschke@fnal.gov Fermi National Accelerator Laboratory
Phone: (630) 840-5645 P.O. Box 500
Fax: (630) 840-2783 Batavia, IL 60510
http://home.fnal.gov/~kutschke/
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:question on The Students' Getting Started Guide
Next Topic:Neural Nets and lcsim.org
Goto Forum:
  


Current Time: Thu Nov 15 00:55:00 Pacific Standard Time 2018
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.1.
Copyright ©2001-2010 FUDforum Bulletin Board Software