Linear Collider Forum

Home » Simulation » slic » compact.xml for a very simple test case
Re: compact.xml for a very simple test case [message #1217 is a reply to message #1216] Mon, 15 October 2007 14:58 Go to previous message
Messages: 80
Registered: January 2004
Hello Hans,
The default segmentation assumes a cartesian coordinate system, where the edge of the cell starts at 0,0 in the x,y plane. That is why you always get four cells. I believe there is an attribute which allows you to shift this. I will check and get back to you. There is no explicit checking that the requested segmentation "fits" the volume. This was intentionally allowed so that one could accomodate odd combinations of geometries and readout schemes.
Read Message
Read Message
Read Message
Read Message
Previous Topic:Phi Inversion?
Next Topic:energy not conserved
Goto Forum:

Current Time: Sun Feb 23 05:26:57 Pacific Standard Time 2020
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.1.
Copyright ©2001-2010 FUDforum Bulletin Board Software