Linear Collider Forum



Home » Simulation » Mokka » Setting pre-init variables
Re: Setting pre-init variables [message #1515 is a reply to message #1514] Mon, 23 June 2008 01:58 Go to previous messageGo to previous message
musat
Messages: 57
Registered: February 2004
Hi,

The commands you showed are steering commands, that should be placed in a steering file (say 'mokka.steer'), that should be used like this:

Mokka mokka.steer

(these commands shouldn't be placed inside a macro file).

The steering file is processed at the beginning, before the detector geometry is built. The macro file commands are executed after that.

Cheers, Gabriel

 
Read Message
Read Message
Read Message
Previous Topic:HCAL number of layers and yoke with plug
Next Topic:lcioDetailedTRKHitMode
Goto Forum:
  


Current Time: Sat Oct 20 03:28:54 Pacific Daylight Time 2018
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.1.
Copyright ©2001-2010 FUDforum Bulletin Board Software