Linear Collider Forum



Home » Software Tools » Marlin et al » detector rotation
detector rotation [message #1609] Wed, 29 October 2008 10:21 Go to previous message
pit1
Messages: 2
Registered: October 2008
Hi,
i've build a detector with components (beampipe, VXD) which are slightly rotated around the x-axes.
My question now is, is it necessary to tell Marlin that angle and if so how ( i mean where does Marlin read the parameters from the gear file and "build" the detectors)?

I'm using the following processors:

<processor name="MyMaterialDB"/>
<processor name="MyVTXDigitizer"/>
<processor name="MyTPCDigiProcessor"/>
<processor name="MyCurlKillerProcessor"/>

<processor name="MyTrackCheater"/>
<processor name="MyLEPTrackingProcessor"/>

<processor name="MySiliconTracking"/>
<processor name="MyFullLDCTracking"/>

<processor name="MyV0Finder"/>
<processor name="MyMarlinVertex2"/>

thanks in advance
cheers

pit
 
Read Message
Read Message
Read Message
Previous Topic:ilcsoft v01-05-pre released
Next Topic:MarlinTPC processor apparently fails to install
Goto Forum:
  


Current Time: Wed Jun 26 10:53:30 Pacific Daylight Time 2019
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.1.
Copyright ©2001-2010 FUDforum Bulletin Board Software