Linear Collider Forum



Home » Software Tools » Marlin et al » How to extract a detailed PadLayout from GEAR?
Re: How to extract a detailed PadLayout from GEAR? [message #1725 is a reply to message #1723] Wed, 15 April 2009 02:50 Go to previous message
oschaefer
Messages: 23
Registered: September 2007
Location: University of Rostock / D...
Does the order of the rows relate in the same way to the gear-file?
So is the first entry there also the "first" row (= row 0) and then increasing row number and y-coordinate?

This is meant for histogramming the XYZ-distribution of pulses instead of hits. Of course I am somewhat limited here if it's not a nicely rectangular, evenly sized pad layout. In principle one would need special histograms for this, representing the pad plane geometry and plotting the information on it. However for the short term it has to work with the normal RAIDA-stuff.
 
Read Message
Read Message
Read Message
Previous Topic:JAS3 and Marlin?
Next Topic:Installing ilcsoft with gcc4
Goto Forum:
  


Current Time: Wed Jun 26 19:07:20 Pacific Daylight Time 2019
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.1.
Copyright ©2001-2010 FUDforum Bulletin Board Software