Linear Collider Forum



Home » Software Tools » org.lcsim » How can I access the current input file from within the lcsim
How can I access the current input file from within the lcsim [message #1854] Fri, 11 September 2009 14:33 Go to previous message
wenzel
Messages: 25
Registered: February 2007
Location: Fermilab
Hi


I would like to automate some processing and would like to access the name of the current input file (where the name is used for some encoding) when running lcsim.org in batch mode. Is there a way to do that. I know there is a way in jas to do that but haven't figured it out yet for lcsim.org


Thanks


Hans
 
Read Message
Read Message
Read Message
Read Message
Previous Topic:Failing to run tutorial: Processing Data in Batch Mode using LCSim XML
Next Topic:JAS3: No information about the Detector Geometry Error
Goto Forum:
  


Current Time: Thu Jul 19 20:13:05 Pacific Daylight Time 2018
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.1.
Copyright ©2001-2010 FUDforum Bulletin Board Software