Linear Collider Forum



Home » Analysis and Reconstruction » Tracking & Vertexing » [MarlinTPC] PulseFinder questions and issues
Re: [MarlinTPC] PulseFinder questions and issues [message #1876 is a reply to message #1861] Mon, 28 September 2009 09:16 Go to previous messageGo to previous message
ralf
Messages: 43
Registered: August 2007
Location: DESY Hamburg
One question arises when implementing the overflow treatment in the PedestalSubstractor:
From where to get the ADCMaxVal?

IMHO it should come from the conditions database. But this is not set up right now. So it would be an effort for testing etc, to write a simple file just for this value ...

Therefore I would propose to make it an optional processor parameter. If it is set, the value from there is taken. If not, the processor looks for an entry in the database.

If neither is there, it throws an exception Wink
I would rather not set a default value there... but the other possibility is not to do anything in case there is no value given.

What do you think?

CU, Ralf.
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:VTXNoiseHits
Next Topic:Alignment for TPC Modules
Goto Forum:
  


Current Time: Wed Dec 12 04:44:41 Pacific Standard Time 2018
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.1.
Copyright ©2001-2010 FUDforum Bulletin Board Software