Linear Collider Forum



Home » Software Tools » LCIO » Seg Fault when adding collections
Re: Seg Fault when adding collections [message #2209 is a reply to message #2207] Wed, 15 February 2012 06:07 Go to previous messageGo to previous message
tonyprice1877
Messages: 16
Registered: September 2010
Location: Birmingham
Hi Frank,

Unfortunately not all my problems were fixed as I first thought... When I just copy the collection with the code I supplied earlier then Marlin runs fine and anajob shows the collection and dumpevent prints all the particles.

What I am actually doing however is forming some jets from the particles and then storing the jets in the lcio.

The
 lccMyJetsOut->setSubset(true); 
flag is once again required or Marlin seg faults and in anajob my jet collection appears but when doing dumpevent it gets to my collection and seg faults without printing any particles. Is there another flag I need since I am reading the particles from "PandoraPFOs" combining some into a new particle and storing again?

Tony
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:LCIO Wiki
Next Topic:Request: addition of "quality" word to TrackerData
Goto Forum:
  


Current Time: Mon May 21 11:54:55 Pacific Daylight Time 2018
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.1.
Copyright ©2001-2010 FUDforum Bulletin Board Software