Linear Collider Forum



Home » Simulation » Full Simulations » Recalibration needed after change in geometry ?
Re: Recalibration needed after change in geometry ? [message #2305 is a reply to message #2304] Fri, 28 February 2014 04:15 Go to previous message
gaede
Messages: 228
Registered: January 2004
Location: DESY, Hamburg
It depends very much on the changes that you make to the geometry.
For example changing the thickness of the scintillator clearly requires new calibration, as would a change of the cell sizes.
In case of doubt, it is best to contact the Pandora experts directly.
-Frank.
 
Read Message icon10.gif
Read Message
Previous Topic:Re-running a given simulations set
Goto Forum:
  


Current Time: Fri Jun 23 10:30:01 Pacific Daylight Time 2017
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.1.
Copyright ©2001-2010 FUDforum Bulletin Board Software