Linear Collider Forum: Full Simulations » Recalibration needed after change in geometry ?

Re: Recalibration needed after change in geometry ? [message #2305 is a reply to message #2304]

Fri, 28 February 2014 04:15

gaede
Messages: 230
Registered: January 2004
Location: DESY, Hamburg

It depends very much on the changes that you make to the geometry.
For example changing the thickness of the scintillator clearly requires new calibration, as would a change of the cell sizes.
In case of doubt, it is best to contact the Pandora experts directly.
-Frank.

Report message to a moderator