Linear Collider Forum



Home » Analysis and Reconstruction » Reconstruction » Alternative to using org.lcsim "TrackSubdetectorHitNumbers" driver (The driver is specific to sidloi3 )
Re: Alternative to using org.lcsim "TrackSubdetectorHitNumbers" driver [message #2325 is a reply to message #2324] Wed, 27 August 2014 06:50 Go to previous messageGo to previous message
jfstrube
Messages: 64
Registered: September 2004
Location: Tohoku University
LCFIPlus makes track selections based on quality cuts in different subdetectors. In SiD we have the convention that we specify subdetectors by identifier. Unfortunately, there is also the option to use an arbitrary number, which is what LCFIPlus chose to do. This is very fragile, and ILD has different "numbers" than SiD, not to mention that they have a TPC and SiD doesn't.

Feel free to modify the driver such that it works for you.
If you can make it work by reading the detector geometry directly, that would be very helpful.

Ideally, LCFIPlus should be modified to read the detector geometry directly, but since this is currently in flux, any change there is unlikely to live very long, either.
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:Problem with Marlin
Next Topic:250 GeV DBD samples
Goto Forum:
  


Current Time: Mon Aug 13 23:45:38 Pacific Daylight Time 2018
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.1.
Copyright ©2001-2010 FUDforum Bulletin Board Software