Linear Collider Forum

Home » Simulation » slic » Range Cuts in SLIC
Range Cuts in SLIC [message #348] Thu, 08 September 2005 07:10
Messages: 2
Registered: March 2005
Hi all,

I run SLIC and try to find out the range cuts for gammas
Running dumpRegion I find this:

Region DefaultRegionForTheWorld
Materials : Air Tungsten G10 Silicon Steel235 Iron PyrexGlass RPCGasDefault Polystyrene Beryllium Aluminum
Production cuts : gamma 1 mm e- 1 mm e+ 1 mm

Region TrackingRegion
Materials : Air CarbonFiber Rohacell31 Beryllium PolystyreneFoam Aluminum G10 Copper PEEK Epoxy Silicon Kapton Titanium
Production cuts : gamma 1 cm e- 1 cm e+ 1 cm

Does the first region correspond to the Silicon of the calorimeter ?? In this case isn't it too big ??

I can change it by /run/setCut or setCutForRegion. The attached plot shows the energy deposited by 1 GeV gammas at 90 degrees in the 30 layers of Si using cdcaug05 geometry. I think this behavior is well known.


  • Attachment: Eraw.png
    (Size: 29.18KB, Downloaded 2329 times)
Read Message
Previous Topic:New SLIC and LCDD Releases
Next Topic:[Q&A]Running SLIC at SLAC (Linear Collider): Extrated from email communication
Goto Forum:

Current Time: Mon Nov 18 13:31:39 Pacific Standard Time 2019
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.1.
Copyright ©2001-2010 FUDforum Bulletin Board Software