Linear Collider Forum

Home » Simulation » slic » Sanity checks on my installation
Re: Sanity checks on my installation [message #504 is a reply to message #502] Fri, 09 June 2006 10:52 Go to previous messageGo to previous message
Messages: 5
Registered: December 2005
I'm basically trying to do some verification of my setup. Here is what I am looking for: a simulation that was already run for which there is known input (lcdd and macro files) and output (slcio file). I'd like to run SLIC with the known input and statistically compare my output with the known output (with JAS3 for instance).

The purpose of this is to see whether or not I can generate results consistent with known good results.

EDIT: I think that I found something on the Confluence Wiki that will help me out - Full Detector Simulation using SLIC. Thanks for your help, Jeremy. I will reply here and mention if that helped me out or not.

[Updated on: Fri, 09 June 2006 11:00]

Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:[Q&A]Running SLIC at SLAC (Linear Collider): Extrated from email communication
Next Topic:slic 2.0
Goto Forum:

Current Time: Thu Jun 20 04:27:47 Pacific Daylight Time 2019
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.1.
Copyright ©2001-2010 FUDforum Bulletin Board Software