Linear Collider Forum



Members   Search   Help    Register    Login   Home
Home » Analysis and Reconstruction » EUDET Telescope » A Marlin processor for pedestal calculation
Re: A Marlin processor for pedestal calculation [message #755 is a reply to message #682] Fri, 02 March 2007 04:46 Go to previous messageGo to previous message
emlyncorrin
Messages: 1
Registered: March 2007
I have another idea of a possible way to handle this. In the Bonn/Mannheim DAQ, they have a beginning-of-run-event (BORE) and an end-of-run-event (EORE) that were sent before the first and after the last real events in a run. They were basically a way for the individual producers to send header/trailer information to the DAQ.
I like the idea of this, and I am going to implement something similar in the final DAQ. These events don't have to be saved to the LCIO output file, but if they are, then the EORE could be used to detect the end of a run, before reaching the end of the file, and without needing to put the number of events in the header.
Report message to a moderator
[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:Important steps toward the EUDET telescope analysis
Next Topic:ilcinstall: configuration file for Eutelescope
Goto Forum:
  

[ Generate printable PDF ]

Current Time: Sat Sep 22 11:35:36 Pacific Daylight Time 2018
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.1.
Copyright ©2001-2010 FUDforum Bulletin Board Software