Linear Collider Forum



Home » Analysis and Reconstruction » Tracking & Vertexing » Reconstructing the z coordinate of a TPC
Re: Reconstructing the z coordinate of a TPC [message #946 is a reply to message #944] Fri, 29 June 2007 02:03 Go to previous messageGo to previous message
wiene
Messages: 23
Registered: June 2006
Location: University of Bonn
Hi,

I prefer to always put z = 0 at the cathode, also for prototypes, to avoid confusion with different coordinate systems which might arise if you do not properly check the processor parameters in the run header.

Cheers, Peter
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic:TrackFitterLikelihood and Minuit
Next Topic:LCFIVertex v00-01 released
Goto Forum:
  


Current Time: Wed Aug 15 15:55:41 Pacific Daylight Time 2018
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.1.
Copyright ©2001-2010 FUDforum Bulletin Board Software